MacDon M200 Operator's Manual download pdf (Page 15)

UNLOADING AND ASSEMBLY

Form 169018 13 Revision C

NOTE

Illustration shows widest tread width.

IMPORTANT

Caster wheels must be equidistant from

center of windrower.

d. Position bracket (A), and install bolts (B). The two

shorter bolts are installed at the back inboard

locations.

e. Install bottom bolts (C).

f. Tighten bolts as follows:

1. Snug bottom bolts (C).

2. Tighten and torque back bolts (B) to 330 ft·lbf

(447 N·m).

3. Tighten and torque bottom bolts (C) to 330

ft·lbf (447 N·m).

g. Lower windrower to ground.

IMPORTANT

Re-torque bolts after first 5, and 10

hours of operation.

STEP 5. INSTALL STEPS

a. Install two ½ in. x 1.0 hex bolts in upper holes in

platform. Do not thread in fully.

b. Hang step assembly (both step assemblies are

the same) on bolts.

c. Install two ½ in. x 1.0 long hex bolts in lower holes

in step, and tighten.

d. Tighten upper bolts installed in step a.

e. Repeat for other step assembly.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 54 55

No comments

MacDon M200 Operator's Manual Page 15