Macdon 4000 Mower Conditioner User Manual download pdf (Page 68)

68

UNLOADING & ASSEMBLY

LOWER MOWER CONDITIONER TO GROUND

1. Drive lifting vehicle to approach mower

conditioner from its "underside".

Attach chain hooks to lean bar at lugs (A) and

(B).

See "Chain Requirements" in this section for

minimum chain specifications.

2. Block wheels at (C) and set 20 inch (500 mm)

blocks (D) to support each end of cutterbar.

3. Raise lifting apparatus to take most of the

weight off mower conditioner wheels and back

up SLOWLY to lower machine onto blocks

(D).

CAUTION: Stand clear when

lowering, as machine may swing.

REMOVE SHIPPING STAND

CAUTION: There are two reinforcing

bars on the underside of hood for

shipping purposes. Stand clear when

loosening bolts (E), as bars will fall

to ground.

1. Remove six bolts (E), remove shipping stand

(F) and replace bolts with six 3/8 x 3/4

carriage bolts provided.

ROTATE LEAN BAR

1. Remove bolts securing lean bar to header.

2. Roll lean bar over so right hand crop divider

(A) points forward.

3. Replace bolts securing lean bar to header.

ATTACH CHAIN HOOKS

LOWER ONTO BLOCKS

REMOVE SHIPPING STAND

ROTATE LEAN BAR

A

1 2 ... 63 64 65 66 67 68 69 70 71 72 73

Comments to this Manuals

No comments