Macdon 4000 Mower Conditioner User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 73
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
31
OPERATION
OPERATING VARIABLES (continued)
7. ROLL GAP
WARNING: To avoid bodily injury or
death from unexpected start-up or
fall of raised machine; stop engine,
remove key and engage lift cylinder
stop before going under machine to
examine roll gap or for any other
reason.
Rubber rolls "condition" the crop by cracking the
stems, while steel rolls crimp the stem in several
places. Both methods allow moisture release for
quicker drying. The degree to which the crop is
conditioned as it passes through the rolls is
controlled by roll gap (A), measured from lug to
groove (or bar to roll tube). The gap is factory set
for normal operation at 1/16 inch (1.5 mm) for
rubber rolls and 3/8 inch (10 mm) for steel rolls.
Correct conditioning of alfalfa, clover and other
legumes is usually indicated when 90% of the
stems show cracking, but no more than 5% of the
leaves are damaged. Use only enough roll gap to
achieve this result.
A slightly larger gap may be desirable in thick
stemmed cane-type crops; however, too large a
gap will cause feeding problems.
Grass type crops may require less gap for proper
feeding.
To adjust roll gap:
a. Loosen nut (B) at both roll support arms.
NOTE: Use roll gap decal (D) to gauge your
adjustment. The decal marks roll gap in 1/8 inch (3
mm) increments. The bottom edge of inner
channel (E) is the gauge indicator.
b. To increase roll gap, turn nut (C) clockwise.
c. To decrease roll gap, turn nut (C) counter-
clockwise.
d. Tighten nut (B) to 160 ft.lbs. (210 N.m) at both
arms.
IMPORTANT: Gap settings must be equal at both
ends of roll. To avoid excessive crushing, do not
operate rubber rolls at less than 1/32 inch (1 mm)
gap.
NOTE: Roll tension (the force holding the rolls
together) is factory set and non-adjustable.
ROLL GAP ADJUSTMENT
E
D
C
B
ROLL GAP (RUBBER ROLLS SHOWN)
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 72 73

Comments to this Manuals

No comments