Macdon D65 User Manual download pdf (Page 26)

LIGHTS

169784 24 Revision A

C. INSTALL SPLICE

This modification is applicable to transport lights

without a module that were manufactured up to

the 2013 model year.

The lighting harness at the endsheet transport

light needs to be modified to include a splice at the

6-pin flat connector. Refer to the electrical

schematic on page 27.

a. Locate the 6-pin flat connector (A) at the end of

the header portion of the electrical harness (B).

b. Unclip and pull back the TPA (Terminal Position

Assurance) clip (C) on connector (A).

c. Locate the wire (D) inside the conduit from pin

position “A” on connector.

d. Pull out a short length to accommodate the splice.

e. Obtain a length of wire (E) the same gauge as the

existing wires for the splice.

f. Attach a pin connector (F), similar to the one

shown to the splice (E).

g. Pull out the green weather plug (G) from position

“F” on connector (A).

h. Insert splice (E) at position “F”.

i. Connect other end of splice to wire (D) from pin

position “A” with a T-type connector, or by

soldering the splice to the existing wire.

j. Insert the connection into the conduit and wrap the

conduit with electrical tape.

k. Reattach the TPA clip (C) on the connector.

CONNECTOR SHOWN WITH CAP REMOVED

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

No comments

Macdon D65 User Manual Page 26