Macdon HC10 for D-Series User Manual download pdf (Page 151)

Model HC10 Hay

Conditioner Predelivery Checklist

Perform these

checks and adjustments prior to delivery to your Customer. Refer to Unloading and A ssembly

Instructions

for adjustment details. The completed checklist should be retained either by the Operator o r the Dealer.

CAUTION

Carefully follow the instructions given. Be alert for safety-related messages, which bring your attention

to hazards and unsafe practices.

Conditioner Serial Number: _____________________________________________



Item Reference

Check for sh ip pin g damage or missing parts. Be sure all s hip ping

dunnage is removed.

—

Check roll drive belt tension. 3.12.1 Checking Roll Drive Belt

Tension, page 59

Check conditioner roll gap, timing, and alignment. 3.12.2 Checking Roll Gap, page 60

and

3.12.3 Checking Roll Timing, page 60

Check rear and side forming shields evenly set to desired position. 3.9 Insta llin g the Forming Sh ield, page

Grease all bearings. 3.11 Lubricating the Conditioner, page

Check roll intermesh hardware is securely tightened. 4.9.2 Adjusting Roll Gap, page 80

Check hydraulic hose routing. 4.3 Attaching Hay Conditioner to

Header, page 65

RUN-UP PROCED URE 3.12.4 Running Up the Conditioner,

page 61

Check reverse operating mode. See windrower manual.

Check hydraulic hose routing for clearance when raising or

lowering header.

—

POST RUN -UP CHECKS. STOP ENGINE.

—

Check for hydraulic leaks.

—

Check belt drive for alignment and heated bearings.

5.7 Drive Belt, page 96

Check manua ls in w in drower cab. 3.12.5 Storing Manuals, page 62

Date checked:

Checked by:

1 2 ... 146 147 148 149 150 151 152 153 154

No comments

Macdon HC10 for D-Series User Manual Page 151