Macdon 9352c SP User Manual Page 135
- Page / 155
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Form # 147459 Issue 11/06 Web Rev_01
133
ASSEMBLY
Install Tires
DRIVE TIRES
Install tires on a hard, level surface as follows:
1. Lift front end of windrower using a forklift and
place 14” (35 cm) blocks under yellow skid
shoes (S) on front frame legs.
2. Install drive tires onto power hubs ensuring tire
tread points forward and air valve stems are on
the outside.
NOTE: For "Turf and Field" tires (diamond or
rectangular tread), be sure arrow on sidewall
points in forward rotation.
3. Torque drive wheel bolts to 180 ft. lbs. (245
N·m)
Follow proper bolt tightening sequence (see
Maintenance/Service section). Re-check torque
as follows:
• Every 15 minutes on the road or 60 minutes in
the field until torque stabilizes, then
• Daily (10 hours) until no change is recorded for
3 consecutive days (30 hours), then
• Every 200 hours or annually thereafter.
4. Lift front end of windrower with forklift and remove the blocks from under skid shoes. Lower the windrower
onto its tires.
5. IMPORTANT: Remove yellow skid shoes (S) from front frame legs.
DRIVE TIRE INFLATION
Check the tire pressures and adjust if necessary.
CAUTION: When inflating tires, use a
clip-on chuck and extension hose long
enough to allow you to stand to one
side and not facing tire.
NOTE: Pressures below are for a fully loaded
header. If hay conditioner is removed, or a bat reel
replaces a pick-up reel, reduce pressures by 2 psi (14
kPa).
Drive Tire Inflation Pressures
Header Model Header Size 14.9 - 24 500 - 70R24 540- 65R24 or 560-65D24
912, 922, 933 All 33 psi (228 kPa) 19 psi (132kPa) 18 psi (125 kPa)
962 All 36 psi (248 kPa) 21 psi (145 kPa) 20 psi (138 kPa)
972 12 - 21 33 psi (228 kPa) 19 psi (132kPa) 18 psi (125 kPa)
972/Sprayer 25 - 36 42 psi (289 kPa) 24 psi (165 kPa) 22 psi (151 kPa)
S
REMOVE
INSTALL DRIVE TIRES & REMOVE SKID SHOES
STAND TO ONE SIDE WHEN INFLATING TIRES
- SELF-PROPELLED 1
- WINDROWER 1
- Proposition 65 Warning 2
- INTRODUCTION 3
- TABLE OF CONTENTS 4
- SERIAL NUMBER LOCATIONS 7
- SAFETY 10
- SPECIFICATIONS 13
- SPECIFICATIONS 14
- TORQUE SPECIFICATIONS 15
- TORQUE SPECIFICATIONS 16
- OPERATOR'S STATION 17
- Symbol Definitions 17
- OPERATOR'S STATION 19
- Mac-Monitor 19
- Mac-Monitor: 20
- Operator Presence System 21
- Speedometer 21
- Ignition Switch 22
- OPERATOR'S STATION 23
- Cab Temperature Controls 23
- Windshield Wiper Control 23
- Windrower Controls 24
- Header Controls 25
- Header Controls (continued) 26
- Seat Belts 27
- Seat Adjustments 28
- Operator Amenities 29
- OPERATION 30
- To the New Operator 30
- Break-in Period 31
- OPERATION 32
- Pre-Starting Checks: Annual 32
- Pre-Starting Checks: Daily 33
- Start-Up Procedure 34
- Driving the Windrower 36
- Stopping Procedure 40
- Leaving the Windrower 41
- Attaching the Header 42
- (continued) 44
- Adding Rear Weight 45
- Detaching the Header 47
- Header Angle 50
- HEADER TILT HYDRAULIC 50
- ADJUSTMENT 50
- Header Levelling 51
- Header Flotation 52
- Transporting the Windrower 53
- Storage Procedure 58
- Service Procedures 59
- Fuels, Fluids and Lubricants 61
- MAINTENANCE/SERVICE 62
- 50 Hours (continued) 64
- 200 Hours or Annually 65
- Diesel Engine 67
- Diesel Engine: Fuel System 72
- Engine Exhaust System 77
- Engine Cooling System 78
- Electrical System 81
- Hydraulic System 90
- Header Drive: Hydraulics 93
- Traction Drive: Hydraulics 98
- Steering Checks 99
- MAINTENANCE/SERVICE 100
- Steering Checks (continued) 100
- MAINTENANCE/SERVICE 101
- Troubleshooting 102
- Procedure (continued) 104
- Friction Device Adjustment 105
- Cab Air System 109
- Maintenance Schedule 112
- MAINTENANCE RECORD 114
- (continued) 115
- TROUBLE SHOOTING 116
- Electrical 124
- Traction Drive System 125
- Header Hydraulics 128
- Header Drive 128
- TROUBLE SHOOTING 129
- Header Drive (continued) 130
- Park Brake 130
- Operator's Seat 130
- OPTIONS AND ATTACHMENTS 131
- B2961 – Fore-Aft 131
- B2962 – Header Tilt 131
- UNLOADING 132
- Prepare to Unload 132
- Two Forklift Method 132
- UNLOADING 133
- One Forklift Method 133
- ASSEMBLY 134
- Install Tires 134
- ASSEMBLY 135
- Battery 136
- ASSEMBLY 137
- Adjustments and Checks 137
- Cab Heater 137
- Preparing the Tractor for 138
- 962/963 & 972 Headers 138
- Preparing 972 Harvest Header 141
- Radio Installation 142
- Two-Way Radio Installation 143
- Tool Box 143
- Swath Roller 144
- Self-Propelled Windrower 149
- Pre-Delivery Checklist 149
- Roof Wiring Schematic 151
- Cab Wiring Schematic 152
- Tractor Wiring Schematic 153
- Form 147141/147459 154
Related products and manuals for Gardening equipment Macdon 9352c SP
Gardening equipment Macdon 9352i SP User Manual
(155 pages)
(155 pages)
Gardening equipment Macdon 9250 SP User Manual
(160 pages)
(160 pages)
Gardening equipment Macdon D65 User Manual
(166 pages)
(166 pages)
Gardening equipment Macdon D65 User Manual
(42 pages)
(42 pages)
Gardening equipment Macdon A-30D User Manual
(140 pages)
(140 pages)
Gardening equipment Macdon A40-D User Manual
(193 pages)
(193 pages)
© 2020, manymanuals.com. All rights reserved. | 0.271 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals