Macdon 9352c SP User Manual Page 26
- Page / 155
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Form # 147459 Issue 11/06 Web Rev_01
24
OPERATOR'S STATION
Header Controls (continued)
REEL HEIGHT SWITCH
(E) - Press top of switch
to raise reel and bottom to lower. Hold switch until
reel reaches desired position.
NOTE: For Auger Headers with Hay Conditioners
equipped with Hydraulic Roll Opener cylinders,
switch (E) controls the operation of these
cylinders.
HEADER HEIGHT SWITCH
(F) - Press top of
switch to raise header and bottom to lower. Hold
switch until header reaches desired position. (See
"Cut Height Indicator").
NOTE: Handle may be rotated on lever to allow
the operator to position switches (E) and (F) for
maximum comfort. To adjust, loosen setscrews on
back of handle.
HEADER EXPRESS DOWN
(Optional)
– This dealer installed option is operated
from switch (G). To activate the express down
function, set switch (G) to “front down” position as
shown. In this mode, it is not necessary to hold
header height switch (F) to lower header fully. A
momentary touch and release of the “down” side of
switch (F) will fully retract header lift cylinders. To
stop express down function in mid-travel, touch and
release the “up” side of switch (F).
To bypass the express down function, set switch
(G) to “rear down” position. Header height switch
(F) will then operate as described at top of page.
REEL FORE-AFT CONTROLS
(H) & (J)
(Optional) – For headers with hydraulic reel fore-
aft option. Press button at (H) to move reel
forward. Press button at (J) to move reel rearward.
HEADER TILT CONTROLS
(K) & (L)
(Optional) – Press button at (K) to tilt header back
for a flatter guard angle. Press button at (L) to tilt
header forward for a steeper guard angle.
IMPORTANT: Do not continue pressing
switches (E) or (F) after header or reel travel is
complete. If switch is held for a long period of
time, damage may occur due to overheating
electrical solenoids and/or over-heating
hydraulic oil, which is pumped through relief
valve.
E
F
K
H
J
L
REEL & HEADER HEIGHT SWITCHES
REEL FORE-AFT & HEADER TILT CONTROLS
G
HEADER EXPRESS DOWN SWITCH
- SELF-PROPELLED 1
- WINDROWER 1
- Proposition 65 Warning 2
- INTRODUCTION 3
- TABLE OF CONTENTS 4
- SERIAL NUMBER LOCATIONS 7
- SAFETY 10
- SPECIFICATIONS 13
- SPECIFICATIONS 14
- TORQUE SPECIFICATIONS 15
- TORQUE SPECIFICATIONS 16
- OPERATOR'S STATION 17
- Symbol Definitions 17
- OPERATOR'S STATION 19
- Mac-Monitor 19
- Mac-Monitor: 20
- Operator Presence System 21
- Speedometer 21
- Ignition Switch 22
- OPERATOR'S STATION 23
- Cab Temperature Controls 23
- Windshield Wiper Control 23
- Windrower Controls 24
- Header Controls 25
- Header Controls (continued) 26
- Seat Belts 27
- Seat Adjustments 28
- Operator Amenities 29
- OPERATION 30
- To the New Operator 30
- Break-in Period 31
- OPERATION 32
- Pre-Starting Checks: Annual 32
- Pre-Starting Checks: Daily 33
- Start-Up Procedure 34
- Driving the Windrower 36
- Stopping Procedure 40
- Leaving the Windrower 41
- Attaching the Header 42
- (continued) 44
- Adding Rear Weight 45
- Detaching the Header 47
- Header Angle 50
- HEADER TILT HYDRAULIC 50
- ADJUSTMENT 50
- Header Levelling 51
- Header Flotation 52
- Transporting the Windrower 53
- Storage Procedure 58
- Service Procedures 59
- Fuels, Fluids and Lubricants 61
- MAINTENANCE/SERVICE 62
- 50 Hours (continued) 64
- 200 Hours or Annually 65
- Diesel Engine 67
- Diesel Engine: Fuel System 72
- Engine Exhaust System 77
- Engine Cooling System 78
- Electrical System 81
- Hydraulic System 90
- Header Drive: Hydraulics 93
- Traction Drive: Hydraulics 98
- Steering Checks 99
- MAINTENANCE/SERVICE 100
- Steering Checks (continued) 100
- MAINTENANCE/SERVICE 101
- Troubleshooting 102
- Procedure (continued) 104
- Friction Device Adjustment 105
- Cab Air System 109
- Maintenance Schedule 112
- MAINTENANCE RECORD 114
- (continued) 115
- TROUBLE SHOOTING 116
- Electrical 124
- Traction Drive System 125
- Header Hydraulics 128
- Header Drive 128
- TROUBLE SHOOTING 129
- Header Drive (continued) 130
- Park Brake 130
- Operator's Seat 130
- OPTIONS AND ATTACHMENTS 131
- B2961 – Fore-Aft 131
- B2962 – Header Tilt 131
- UNLOADING 132
- Prepare to Unload 132
- Two Forklift Method 132
- UNLOADING 133
- One Forklift Method 133
- ASSEMBLY 134
- Install Tires 134
- ASSEMBLY 135
- Battery 136
- ASSEMBLY 137
- Adjustments and Checks 137
- Cab Heater 137
- Preparing the Tractor for 138
- 962/963 & 972 Headers 138
- Preparing 972 Harvest Header 141
- Radio Installation 142
- Two-Way Radio Installation 143
- Tool Box 143
- Swath Roller 144
- Self-Propelled Windrower 149
- Pre-Delivery Checklist 149
- Roof Wiring Schematic 151
- Cab Wiring Schematic 152
- Tractor Wiring Schematic 153
- Form 147141/147459 154
Related products and manuals for Gardening equipment Macdon 9352c SP
Gardening equipment Macdon 9352i SP User Manual
(155 pages)
(155 pages)
Gardening equipment Macdon 9250 SP User Manual
(160 pages)
(160 pages)
Gardening equipment Macdon D65 User Manual
(166 pages)
(166 pages)
Gardening equipment Macdon D65 User Manual
(42 pages)
(42 pages)
Gardening equipment Macdon A-30D User Manual
(140 pages)
(140 pages)
Gardening equipment Macdon A40-D User Manual
(193 pages)
(193 pages)
© 2020, manymanuals.com. All rights reserved. | 0.149 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals