Macdon 9250 SP User Manual Page 83
- Page / 160
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Form # 46584 Issue 11/06 Web Rev_01
81
MAINTENANCE/SERVICE
Electrical System
BATTERY (continued)
PREVENTING BATTERY DAMAGE
1. Be sure alternator connections are correct before cables are connected to battery. See "Preventing
Alternator and Regulator Damage" in this section.
2. Carefully observe polarity when attaching booster battery.
3. Do not operate the engine with alternator or battery disconnected.
WARNING: With battery cables disconnected and engine running, a high voltage can be built
up if terminals touch the frame. Anyone touching the frame under these conditions would be
severely shocked.
4. Do not short across battery or alternator terminals, or allow battery positive (+) cable or alternator wire to
become grounded.
5. Do not polarize the alternator.
6. When welding on any part of the machine, disconnect battery cables and alternator wire.
7. To prolong battery life, store batteries fully charged and at +20° to +80°F (-7° to +26°C). Check voltage after
storage and recharge as needed, according to battery and charger manufacturer recommendations.
8. Do not stack storage batteries on top of each other.
CAUTION: When working around storage batteries, remember that all of the exposed metal
parts are "live". Never lay a metal object across the terminals because a spark or short
circuit will result.
BATTERY MAINTENANCE
CAUTION: Do not attempt to service battery unless you have the proper equipment and
experience to perform the job. Have it done by a qualified dealer.
1. Check fluid level once a year
. If necessary add distilled water (or clean rain water) to bring level to bottom
of cell neck. Do not add water in freezing temperatures unless engine is run two to three hours to mix
electrolyte.
2. Check battery charge once a year
, more often if operating in cold weather. Hydrometer readings should be
1.260 to 1.300. Readings below 1.250 indicate charging is required. See "Charging Battery".
3. Keep battery clean by wiping it with a damp cloth.
4. Keep all connections clean and tight. Remove any corrosion and wash terminals with a solution of baking
soda and water. A light coating of grease on terminals (after cables are attached) will reduce corrosion.
5. A replacement battery must have a rating of at least 640 cold cranking amps at 0°F (-18°C).
IMPORTANT: BATTERY IS NEGATIVE GROUNDED. Always connect starter cable to the positive (+)
terminal of battery and battery ground cable to negative (-) terminal of battery. Reversed polarity in battery or
alternator may result in permanent damage to electrical system.
- 9250/9350/9352 1
- SELF-PROPELLED 1
- WINDROWER 1
- Proposition 65 Warning 2
- INTRODUCTION 3
- TABLE OF CONTENTS 4
- SERIAL NUMBER LOCATIONS 7
- SAFETY 10
- SPECIFICATIONS 13
- SPECIFICATIONS 14
- TORQUE SPECIFICATIONS 15
- TORQUE SPECIFICATIONS 16
- OPERATOR'S STATION 17
- Symbol Definitions 17
- OPERATOR'S STATION 19
- Mac-Monitor 19
- Mac-Monitor: 20
- Operator Presence System 21
- Speedometer 21
- Ignition Switch 22
- OPERATOR'S STATION 23
- Cab Temperature Controls 23
- Windshield Wiper Control 23
- Windrower Controls 24
- Header Controls 25
- Header Controls (continued) 26
- Seat Belts 27
- Seat Adjustments 28
- Operator Amenities 29
- OPERATION 30
- To the New Operator 30
- Break-in Period 31
- OPERATION 32
- Pre-Starting Checks: Annual 32
- Pre-Starting Checks: Daily 33
- Start-Up Procedure 34
- Driving the Windrower 36
- Stopping Procedure 40
- Leaving the Windrower 41
- Attaching the Header 42
- (continued) 44
- Adding Rear Weight 45
- Detaching the Header 47
- Header Angle 50
- HEADER TILT HYDRAULIC 50
- ADJUSTMENT 50
- Header Levelling 51
- Header Flotation 52
- Transporting the Windrower 53
- Storage Procedure 58
- Service Procedures 59
- Fuels, Fluids and Lubricants 61
- 50 Hours (continued) 64
- 200 Hours or Annually 65
- Diesel Engine 67
- Diesel Engine (continued) 69
- Diesel Engine: Fuel System 73
- Engine Exhaust System 78
- Engine Cooling System 79
- Electrical System 82
- Hydraulic System 91
- Header Drive: Hydraulics 94
- Traction Drive: Hydraulics 99
- MAINTENANCE/SERVICE 100
- Steering Checks 100
- MAINTENANCE/SERVICE 101
- Steering Checks (continued) 101
- Troubleshooting 103
- Procedure (continued) 105
- Friction Device Adjustment 106
- AT HALF-WEAR STAGE 110
- MAINTENANCE/SERVICE 111
- Traction Drive: Park Brake 111
- Cab Air System 112
- Maintenance Schedule 115
- MAINTENANCE RECORD 117
- (continued) 118
- TROUBLE SHOOTING 119
- Electrical 127
- Traction Drive System 128
- Header Hydraulics 131
- Header Drive 131
- TROUBLE SHOOTING 132
- Header Drive (continued) 133
- Park Brake 133
- Operator's Seat 133
- OPTIONS AND ATTACHMENTS 134
- UNLOADING 135
- Prepare to Unload 135
- Two Forklift Method 135
- UNLOADING 136
- One Forklift Method 136
- ASSEMBLY 137
- Install Tires 137
- ASSEMBLY 140
- Battery 140
- ASSEMBLY 141
- Adjustments and Checks 141
- Cab Heater 141
- Preparing the Tractor for 142
- Preparing 972 Harvest Header 145
- Radio Installation 146
- Two-Way Radio Installation 147
- Tool Box 147
- Swath Roller 148
- INDEX 150
- Self-Propelled Windrower 153
- Pre-Delivery Checklist 153
- Roof Wiring Schematic 155
- Cab Wiring Schematic 156
- Tractor Wiring Schematic 157
Related products and manuals for Gardening equipment Macdon 9250 SP
Gardening equipment Macdon D65 User Manual
(166 pages)
(166 pages)
Gardening equipment Macdon D65 User Manual
(42 pages)
(42 pages)
Gardening equipment Macdon A-30D User Manual
(140 pages)
(140 pages)
Gardening equipment Macdon A40-D User Manual
(193 pages)
(193 pages)
Gardening equipment Macdon 922 User Manual
(84 pages)
(84 pages)
© 2020, manymanuals.com. All rights reserved. | 0.110 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals