MAINTENANCE AND SERVICING
Inspecting Accelerators
Follow these steps to inspect accelerators:
DANGER
Stop engine an
d remove key from ignition before
leaving opera
tor’s seat for any reason. A child or
even a pet cou
ld engage an idling machine.
1. Raise header fully, stop engine, and remove key.
2. Engage header safety props.
3. Open cutterbar doors. Refer to Section 5.5 Cutterbar
Doors, page 31 .
CAUTION
Cutter blades have two cutting edges. Exercise
caution when working around the blades. Blades
are sharp and can cause serious injury. Wear
gloves when handling blades.
Figure 7.35
4. Inspect accelerators for damage and wear. They
should be replaced if severely damaged or worn.
5. Check for loose or missing fasteners and tighten or
replace fastener if missing.
Replacing Accelerato
rs
Follow these steps to replace the accelerators:
1. Raise header fully, shut off engine, and remove key.
2. Engage header safety props.
3. Remove disc. See Removing a Disc, page 127.
169457 1
35
Rev. F
Comments to this Manuals