Macdon R85 Rotary Disc 16 Foot Self-Propelled Windrower H User Manual Page 170

  • Download
  • Add to my manuals
  • Print
  • Page
    / 182
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 169
TROUBLESHOOTING
8.2 Mechanical
Symptom Problem Solution Section
Bent cutter blade Repla ce blade.
Replacing the Cutter
Blades, page 132
Conditioner roll timing off
Check roll timing and
adjust if necessary.
6.4 Roll Timing, page 71
Excessive noise
Conditioner roll gap too
small
Check gap and adjust if
necessary.
Increase roll gap.
6.2 Roll Gap, page 67
Conditioner rolls
contacting each other
Check roll timing. 6.4 Roll T
iming, page 71
Auger center support
loose
Tighten bolts on support.
6.12.1 Adjusting the
Overshot Auger, page 90
Excessive vibration or
noise in header
Mud deposits on
conditioner r olls
Clean ro
lls.
Excessive heat in
cutterbar
Too much lubricant in
cutterbar
Drain lubricant and rell
with specied amount.
7.5.8 Lubricating the
Cutterbar, page 121
Mud on
cutterbar
Remove mud from
cutterbar. Do not allow
mudtodryoncutterbar.
Spindle bearing failure
Replace spindle bearing.
SeeMacDonDealer.
Material wrapped around
spindle
Remove dis c and remo ve
material.
7.6 Cutterbar Disc
Maintenance, page 126
Cut
ting too low in ro cky
el
d c onditions
Decrease header angle.
Increase oat.
6.6 Header Angle, page
78 and 6.1 Header Float,
page 65
Ground speed too high
in roc ky eld conditions.
At High ground speed,
header tends to dig rocks
from ground instead of
oating ov er t hem
Reduce ground speed.
6.8 G round Speed, page
81
B
lade incorrectly mounted
Check all blade m ounting
hardware en suring blades
arefreetomove.
Inspecting Cu tt er Blades,
page 130
Frequent blade damage
Header oat set too heavy Increase oat.
Machine pullin g to one
side
Header dragging to one
end and pullin g to th at
side
Adjust header oat on
both ends.
6.1 Header Float, page 65
169457 1
62
Rev. F
Page view 169
1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 181 182

Comments to this Manuals

No comments