MacDon 9352 Operator's Manual Page 48
- Page / 160
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Form # 46584 Issue 11/06 Web Rev_01
46
OPERATION
Detaching the Header
(continued)
DANGER: Wait for all movement to
stop. A rotating driveline can cause
entanglement resulting in serious
personal injury or death.
8. Disconnect driveline from header shaft as
follows:
• Pull back spring-loaded collar on driveline
yoke and remove yoke from header shaft.
• Detach chain (if present) from header
hinged shield.
• Pull back spring-loaded collar and store
driveline on pin welded to tractor frame at
(E).
9. Disconnect hydraulic hoses at quick couplers at
right and left-hand legs.
IMPORTANT: Where possible, connect hoses
to each other for storage except fore-aft as
noted below. Plug or cap all other couplers to
prevent hydraulic system contamination. Store
tractor reel drive hoses as shown at (G) to avoid
interference during hook-up.
WARNING: For headers with
hydraulic reel fore-aft, never connect
the header fore-aft couplers to each
other. This would complete the circuit
and allow the reel to creep forward in
transport, resulting in instability.
10. Disconnect electrical wiring harness.
NOTE: If a Hay Conditioner is installed, detach
supports between tractor frame and conditioner
forming shield.
11. Adjust length of center link to release load on
pins. Disconnect center link at header by
removing pin (C).
12. Slowly back tractor away from header. If hay
conditioner is attached, watch clearances at left
and right sides.
WARNING: Avoid driving the tractor
with header removed. Removing
header decreases the weight on
drive wheels, reducing steering
control. If necessary to drive tractor with
header removed, use transmission low speed
range, do not exceed half-maximum engine
speed and avoid loose gravel and slopes.
WARNING: Harvest Header with
Transport Option This windrower
tractor is not intended as a towing
vehicle for the Harvest Header
Transport configuration. If necessary to use
the tractor in this manner, add a minimum 2000
lb. (910 kg) counterweight on the lift linkage.
G
TRACTOR REEL DRIVE HOSES - STORAGE
DETACH CENTER LINK AT HEADER
E
DETACH AND STORE DRIVELINE
- 9250/9350/9352 1
- SELF-PROPELLED 1
- WINDROWER 1
- Proposition 65 Warning 2
- INTRODUCTION 3
- TABLE OF CONTENTS 4
- SERIAL NUMBER LOCATIONS 7
- SAFETY 10
- SPECIFICATIONS 13
- SPECIFICATIONS 14
- TORQUE SPECIFICATIONS 15
- TORQUE SPECIFICATIONS 16
- OPERATOR'S STATION 17
- Symbol Definitions 17
- OPERATOR'S STATION 19
- Mac-Monitor 19
- Mac-Monitor: 20
- Operator Presence System 21
- Speedometer 21
- Ignition Switch 22
- OPERATOR'S STATION 23
- Cab Temperature Controls 23
- Windshield Wiper Control 23
- Windrower Controls 24
- Header Controls 25
- Header Controls (continued) 26
- Seat Belts 27
- Seat Adjustments 28
- Operator Amenities 29
- OPERATION 30
- To the New Operator 30
- Break-in Period 31
- OPERATION 32
- Pre-Starting Checks: Annual 32
- Pre-Starting Checks: Daily 33
- Start-Up Procedure 34
- Driving the Windrower 36
- Stopping Procedure 40
- Leaving the Windrower 41
- Attaching the Header 42
- (continued) 44
- Adding Rear Weight 45
- Detaching the Header 47
- Header Angle 50
- HEADER TILT HYDRAULIC 50
- ADJUSTMENT 50
- Header Levelling 51
- Header Flotation 52
- Transporting the Windrower 53
- Storage Procedure 58
- Service Procedures 59
- Fuels, Fluids and Lubricants 61
- 50 Hours (continued) 64
- 200 Hours or Annually 65
- Diesel Engine 67
- Diesel Engine (continued) 69
- Diesel Engine: Fuel System 73
- Engine Exhaust System 78
- Engine Cooling System 79
- Electrical System 82
- Hydraulic System 91
- Header Drive: Hydraulics 94
- Traction Drive: Hydraulics 99
- MAINTENANCE/SERVICE 100
- Steering Checks 100
- MAINTENANCE/SERVICE 101
- Steering Checks (continued) 101
- Troubleshooting 103
- Procedure (continued) 105
- Friction Device Adjustment 106
- AT HALF-WEAR STAGE 110
- MAINTENANCE/SERVICE 111
- Traction Drive: Park Brake 111
- Cab Air System 112
- Maintenance Schedule 115
- MAINTENANCE RECORD 117
- (continued) 118
- TROUBLE SHOOTING 119
- Electrical 127
- Traction Drive System 128
- Header Hydraulics 131
- Header Drive 131
- TROUBLE SHOOTING 132
- Header Drive (continued) 133
- Park Brake 133
- Operator's Seat 133
- OPTIONS AND ATTACHMENTS 134
- UNLOADING 135
- Prepare to Unload 135
- Two Forklift Method 135
- UNLOADING 136
- One Forklift Method 136
- ASSEMBLY 137
- Install Tires 137
- ASSEMBLY 140
- Battery 140
- ASSEMBLY 141
- Adjustments and Checks 141
- Cab Heater 141
- Preparing the Tractor for 142
- Preparing 972 Harvest Header 145
- Radio Installation 146
- Two-Way Radio Installation 147
- Tool Box 147
- Swath Roller 148
- INDEX 150
- Self-Propelled Windrower 153
- Pre-Delivery Checklist 153
- Roof Wiring Schematic 155
- Cab Wiring Schematic 156
- Tractor Wiring Schematic 157
© 2020, manymanuals.com. All rights reserved. | 0.228 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals