MacDon M200 Operator's Manual download pdf (Page 160)

MAINTENANCE AND SERVICING - M200 ENGINE

Form 169017 / 169087 / 169095 158 Revision C

IMPORTANT

Do not remove the secondary filter element

(J) unless it needs replacing. Do not

attempt to clean the secondary (inner)

element.

1. Hold a bright light inside primary element (H),

and check carefully for holes. Discard any

element that shows the slightest hole.

2. Be sure outer screen is not dented. Vibration

would quickly wear a hole in the filter.

3. Be sure filter gasket is in good condition. If

gasket is damaged or missing, replace

element.

4. If element is coated with oil or soot, replace

the element.

d. Inspect the air intake piping for damage, cracked

hoses, loose clamps, etc. Repair or replace

damaged parts, and tighten loose clamps.

e. Check the secondary element (J) for cleanliness.

If there is visible dirt on the secondary element,

replace both primary and secondary elements.

IMPORTANT

The air cleaner's primary (outer) filter

element should be replaced after six

cleanings, or at least every three years.

IMPORTANT

The secondary (inner) element should be

replaced every third time the primary

element is changed.

f. Clean inside of canister, and cover with a damp

cloth.

IMPORTANT

Leave secondary element in place to

prevent ingress of dirt into engine intake.

g. Pat sides of primary element gently to loosen dirt.

Do not tap element against a hard surface.

h. Using a Dry Element Cleaner Gun, clean element

with compressed air.

i. Hold nozzle next to inner

surface, and move up

and down pleats.

IMPORTANT

Air pressure must not exceed 100 psi (700

kPa). Do not direct air against outside of

element, as dirt might be forced through to

inside.

j. Repeat steps h. and i. to remove additional dirt.

k. Repeat inspection before installing.

l. To remove the secondary element (J), pull it out of

the canister.

m. Insert secondary filter element into canister, seal

first, and push until seal is seated inside canister.

IMPORTANT

When replacing secondary filter, reinsert

new filter as soon as possible to prevent dirt

entering engine intake

(continued next page)

HOLD 0.018 in. (0.46 mm)

GAUGE BETWEEN MIDDLE

COILS & TIGHTEN CLAMP

UNTIL GAUGE IS SNUG

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 233 234

Comments to this Manuals

No comments

MacDon M200 Operator's Manual Page 160

Comments to this Manuals

Related products and manuals for Tractor MacDon M200