MacDon M200 Operator's Manual download pdf (Page 173)

MAINTENANCE AND SERVICING - M200 ENGINE

Form 169017 / 169087 / 169095 171 Revision C

7.9.8.2 Changing Lubricant

Change gearbox lubricant after the first 50 hours,

and then at 500 hours as follows:

NOTE

The engine should be warm prior to

changing the oil.

DANGER

Stop engine and remove key from ignition

before leaving Operator’s seat for any reason.

A child or even a pet could engage an idling

machine.

a. Stop the engine, and remove the key.

b. Place a drain pan of about 1 U.S. gallon (4 litres)

under the gearbox.

c. Remove drain plug (C), and allow the oil to

completely finish draining.

d. Install the drain plug (C), and remove the check

plug (A).

e. Unscrew breather cap (B), and add lubricant. The

gearbox will require 2.2 U.S. quarts (2.1 litres).

Add sufficient lubricant until it slightly runs out of

hole (A). Use SAE 75W-90 API Service Class GL-

5, Fully Synthetic Transmission Lubricant. SAE

J2360 preferred.

f. Replace check plug (A).

g. Operate the engine at low idle for a short time and

shutdown.

DANGER

Stop engine and remove key from ignition

before leaving Operator’s seat for any reason.

A child or even a pet could engage an idling

machine.

h. Check for leaks at the check plug and drain plug.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 233 234

No comments

MacDon M200 Operator's Manual Page 173