MacDon M200 Operator's Manual Page 217
- Page / 234
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
TROUBLESHOOTING
* See your MacDon dealer
** Refer to Windrower Technical Manual
Form 169017 / 169087 / 169095 215 Revision C
8.2 ELECTRICAL
SYMPTOM PROBLEM SOLUTION
SECTION
M150 M200
Low Voltage
And/Or
Battery Will Not
Charge.
Defective battery. Have battery tested. 7.11.1
Defective alternator belt. Replace worn belt. 7.8.10.3 7.9.10.3
Loose or corroded connections. Clean and tighten battery connections. 7.11.1
Dirty or defective alternator,
defective voltage regulator, or high
resistance in circuit.
Contact MacDon Dealer.
*
Alternator or voltage regulator not
connected properly.
Connect properly. 7.11.1.6
Lights Dim.
High resistance in circuit or poor
ground on lights.
Check the wiring circuit for a break in a wire
or a poor ground.
---
Defective light switch.
Contact MacDon Dealer.
*
Lights Do Not
Light.
Burnt out light bulb Replace light bulb 7.11.2 to 7.11.11
Defective light switch.
Contact MacDon Dealer.
*
Broken wiring. Check wiring for broken wire or shorts. ---
Open or defective circuit breaker. Check circuit breaker
7.11.13
Defective relay. Replace relay.
Poor ground on lights.
Clean and tighten ground wires.
---
Turn Signals Or
Indicators
Showing Wrong
Direction.
Reversed wires.
Contact MacDon Dealer.
*
No Current To
Cab.
Circuit breaker tripped. Breaker automatically resets. ---
Broken or disconnected wire.
Contact MacDon Dealer.
*
Battery disconnect switch is off.
Turn on switch.
7.11.1.2
8.3 HYDRAULICS
SYMPTOM PROBLEM SOLUTION
SECTION
M150 M200
Header Or Reel Not
Lifting.
Contaminant in relief valve. Clean relief valve at cylinder control valve. **
Appropriate solenoids not being
energized by activating switch.
Contact MacDon Dealer.
*
Header Or Reel
Lifts But Lacks
Power.
Relief pressure too low or
contaminant in relief valve.
Check / adjust / clean relief valve at cylinder
control valve.
**
Reel And/Or
Conveyor Not
Turning.
Header drive switch not engaged. Engage switch. 5.17.1
Flow controls adjusted too low.
Toggle speed controls on CDM to increase
flow.
6.5.6, 6.5.7, 6.6.3,
& 6.6.4
Appropriate solenoid on flow
control block not being energized.
Contact MacDon Dealer.
*
Reel And/Or
Conveyor Turns,
But Lacks Power.
Relief pressure too low. Check / adjust / clean compensator pump. **
- M150 & M200 1
- Self-Propelled Windrowe 1
- Proposition 65 Warning 2
- 1 INTRODUCTION 3
- TABLE OF CONTENTS 4
- 2 SAFETY 8
- 7 Revision C 9
- 8 Revision C 10
- Safety Sign Locations 10
- 9 Revision C 11
- 10 Revision C 12
- 12 Revision C 14
- 3 DEFINITIONS 15
- 4 SPECIFICATIONS 16
- SPECIFICATIONS 17
- 4.2 SPECIFICATIONS 17
- 5 OPERATOR’S STATION 19
- OPERATOR’S STATION 20
- 5.2 OPERATOR PRESENCE 20
- 5.3 SEAT ADJUSTMENTS 20
- 5.7 LIGHTS 22
- 5.8 WINDSHIELD WIPERS 25
- 5.9 REAR VIEW MIRRORS 25
- 5.10 CAB TEMPERATURE 25
- 5.11 INTERIOR LIGHTS 26
- 5.12 OPERATOR AMENITIES 27
- 5.13 RADIOS 28
- 5.14 HORN 28
- 5.15 ENGINE CONTROLS/GAUGES 29
- 5.16 WINDROWER CONTROLS 30
- 5.17 HEADER CONTROLS 31
- 5.18.3 OPERATING SCREENS 36
- 34 Revision C 36
- 35 Revision C 37
- AUGER HEADER 38
- 37 Revision C 39
- 38 Revision C 40
- ROTARY HEADER 41
- 40 Revision C 42
- DISPLAY WARNINGS AND ALARMS 44
- 43 Revision C 45
- 6 OPERATION 53
- WINDROWER OPERATION 54
- HEADER - GENERAL 79
- 6.4 HEADER OPERATION 79
- + to increase float, or 82
- HEADER OPERATION - D SERIES 91
- CAUTION 100
- HEADER OPERATION - A SERIES 104
- HEADER OPERATION - R SERIES 112
- SERVICING 118
- 7 MAINTENANCE AND 118
- MAINTENANCE AND SERVICING 119
- 7.4 ENGINE COMPARTMENT HOOD 123
- 7.5 MAINTENANCE PLATFORMS 124
- WARNING 126
- 7.7 OPERATOR’S STATION 128
- 136 Revision C 138
- 7.8.3 OIL LEVEL 138
- 138 Revision C 140
- 139 Revision C 141
- 7.8.5 AIR INTAKE SYSTEM 141
- 140 Revision C 142
- 141 Revision C 143
- 143 Revision C 145
- 144 Revision C 146
- 145 Revision C 147
- 147 Revision C 149
- 7.8.7 ENGINE COOLING SYSTEM 149
- 149 Revision C 151
- 151 Revision C 153
- 153 Revision C 155
- 7.8.10 BELTS 155
- 154 Revision C 156
- 7.8.11 ENGINE SPEED 156
- 156 Revision C 158
- 157 Revision C 159
- 7.9.4 AIR INTAKE SYSTEM 159
- 158 Revision C 160
- 159 Revision C 161
- VALVE REPLACEMENT 161
- 160 Revision C 162
- 162 Revision C 164
- 163 Revision C 165
- 164 Revision C 166
- 166 Revision C 168
- 7.9.7 ENGINE COOLING SYSTEM 168
- 169 Revision C 171
- 171 Revision C 173
- 173 Revision C 175
- 7.9.10 BELTS 175
- 174 Revision C 176
- 7.10 COOLING BOX 177
- 49.75 in 186
- (1263 mm) 186
- 7.13 WHEELS AND TIRES 203
- INTERVAL SERVICE 211
- 8 TROUBLESHOOTING 214
- TROUBLESHOOTING 215
- 8.2 ELECTRICAL 217
- 8.3 HYDRAULICS 217
- 8.4 HEADER DRIVE 218
- 8.5 TRACTION DRIVE 218
- 8.7 CAB AIR 220
- 8.8 OPERATOR’S STATION 222
- 9 OPTIONS / ATTACHMENTS 223
- 222 Model Year - 2010 224
- 223 Revision C 225
- 224 Model Year - 2010 226
- 225 Revision C 227
- 226 Revision C 228
- 227 Revision C 229
- 228 Revision C 230
- 229 Revision C 231
- 230 Revision C 232
- 231 Revision C 233
- 232 Revision C 234
Related products and manuals for Tractor MacDon M200
Tractor MacDon 9352 Specifications
(115 pages)
(115 pages)
Tractor MacDon M200 Operator's Manual
(55 pages)
(55 pages)
Tractor MacDon M200 Operator's Manual
(41 pages)
(41 pages)
Tractor MacDon M200 User Manual
(1 pages)
(1 pages)
© 2020, manymanuals.com. All rights reserved. | 1.921 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals