MacDon M200 Operator's Manual download pdf (Page 79)

HEADER - GENERAL

Form 169017 / 169087 / 169095 77 Revision C

6.4 HEADER OPERATION

The M150 and M200 Windrowers are designed to

use the MacDon A Series Auger Header, R Series

Rotary Header, and D Series Rigid Draper

Header, with or without a Hay Conditioner.

This section describes attachment and

detachment procedures, and operating

instructions for these header types.

6.4.1 HEADER LIFT CYLINDER STOPS

Cylinder stops are located on both header lift

cylinders on the windrower.

To avoid bodily injury or death from fall of raised

header, always engage cylinder stops before

going under header for any reason.

Engage cylinder stops as follows:

a. Press HEADER UP switch to raise header to

maximum height.

NOTE

If one end of the header does not raise fully,

the lift cylinders require re-phasing.

Proceed as follows:

1. Press and hold the HEADER UP switch until

both cylinders stop moving.

2. Continue to hold the switch for 3 - 4 seconds.

3. Cylinders are phased.

b. Pull lever (A), and rotate toward header to release

and lower cylinder stop (B) onto cylinder. Repeat

for both lift cylinders.

c. To store, turn lever (A) away from header to raise

stop until lever locks into vertical position.

HEADER UP

HEADER DOWN

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 233 234

No comments

MacDon M200 Operator's Manual Page 79