MacDon 9352 Operator's Manual download pdf (Page 25)

Form # 46584 Issue 11/06 Web Rev_01

OPERATOR'S STATION

Header Controls

HEADER DRIVE SWITCH

(A) - Lift the guard to

expose toggle switch. Push toggle switch forward

to engage all header mechanical and hydraulic

drives. Push guard down to disengage drives.

Starter will not engage if switch is in the engaged

position.

NOTE: Always move throttle lever back to idle

before engaging header drives. Do not engage

with engine at full RPM.

CONVEYOR SPEED CONTROL

(B) - Turn knob

clockwise to increase conveyor speed and

counter-clockwise to decrease. Speed range is:

940 Series Headers, Auger speed: 175 - 500 RPM

960/970 Series Headers, Draper speed:

170 to 500 ft/min (50 - 155 m/min)

REEL SPEED CONTROL

clockwise to increase reel speed and counter-

clockwise to decrease. Speed range is:

920 Series Headers: 30 to 75 RPM

930 Series Headers: 30 to 69 RPM

940/960/970 Series Headers: 20 to 60 RPM

NOTE: 920/930 Series Headers

– For these

headers, both controls (B) and (C) affect reel

speed. Set conveyor speed knob (B) to "10" and

adjust reel speed knob (C) to obtain desired reel

speed.

DECK SHIFT SWITCH

(D) – Press left side of

rocker switch to shift decks to the left and reverse

draper travel. Press right side of switch to shift

decks to the right and reverse draper travel. For

center delivery, move rocker to center position.

NOTE: Some of these controls are not used

for all types of headers. Some are optional

equipment and may not be present in your unit.

For others, while the switch may be installed, it

will be non-functional for certain headers.

HEADER DRIVE / CONVEYOR SPEED

REEL SPEED / DECK SHIFT CONTROLS

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 159 160

Comments to this Manuals

No comments

MacDon 9352 Operator's Manual Page 25

Comments to this Manuals