MacDon 9352 Operator's Manual Page 92
- Page / 160
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Form # 46584 Issue 11/06 Web Rev_01
90
MAINTENANCE/SERVICE
Hydraulic System
HYDRAULIC OIL
Change hydraulic oil every 2000 hours
.
NOTE FOR FLEET OWNERS: If you also operate
an older MacDon built windrower tractor with a
production year ’99 or earlier, that unit’s hydraulic
system will be filled with 10W30 engine oil. It is
recommended that the change be made to single
grade trans-hydraulic oil at the next scheduled oil
change. See page 59 for recommended brand
names.
To change:
1. Remove drain plug (B) from bottom of reservoir.
Allow oil to drain.
NOTE: A drain pan with a capacity of 20 U.S.
gallons (75 litres) will be required.
2. Replace the hydraulic oil filter. See "Hydraulic
Oil Filters" in this section.
3. Clean off any metal debris which may have
accumulated on magnetic drain plug. Replace
plug (B).
4. Fill the system with oil through the filler neck.
See "Fuels, Fluids and Lubricants" page 59 for
recommended oil type. Check oil level with
dipstick periodically during filling to prevent spill-
over.
CAPACITY
:
Reservoir only: 15.2 US gal. (57 litres)
Total system: approximately 17 US gal.
(65 litres)(varies with options)
HYDRAULIC OIL FILTERS
Change hydraulic oil filters after the first 10 hours
of operation and every 300 hours thereafter.
• Filter (A) is located at right side of engine
compartment, under side panel.
• Filter (B) is located just ahead of frame cross
channel, near hydrostatic pump.
To change:
1. Clean around the filter head.
2. Remove the filter element and clean the gasket
surface of the filter head.
3. Apply a thin film of clean oil to the gasket on the
new filter.
4. Install new filter. Turn the filter onto the mount
until the gasket contacts the filter head. Tighten
the filter an additional ½ turn by hand.
IMPORTANT: Do not use a filter wrench to install
the oil filter. Over-tightening can damage gasket
and filter.
B
TO DRAIN HYDRAULIC OIL
A
B
HYDRAULIC OIL FILTERS
- 9250/9350/9352 1
- SELF-PROPELLED 1
- WINDROWER 1
- Proposition 65 Warning 2
- INTRODUCTION 3
- TABLE OF CONTENTS 4
- SERIAL NUMBER LOCATIONS 7
- SAFETY 10
- SPECIFICATIONS 13
- SPECIFICATIONS 14
- TORQUE SPECIFICATIONS 15
- TORQUE SPECIFICATIONS 16
- OPERATOR'S STATION 17
- Symbol Definitions 17
- OPERATOR'S STATION 19
- Mac-Monitor 19
- Mac-Monitor: 20
- Operator Presence System 21
- Speedometer 21
- Ignition Switch 22
- OPERATOR'S STATION 23
- Cab Temperature Controls 23
- Windshield Wiper Control 23
- Windrower Controls 24
- Header Controls 25
- Header Controls (continued) 26
- Seat Belts 27
- Seat Adjustments 28
- Operator Amenities 29
- OPERATION 30
- To the New Operator 30
- Break-in Period 31
- OPERATION 32
- Pre-Starting Checks: Annual 32
- Pre-Starting Checks: Daily 33
- Start-Up Procedure 34
- Driving the Windrower 36
- Stopping Procedure 40
- Leaving the Windrower 41
- Attaching the Header 42
- (continued) 44
- Adding Rear Weight 45
- Detaching the Header 47
- Header Angle 50
- HEADER TILT HYDRAULIC 50
- ADJUSTMENT 50
- Header Levelling 51
- Header Flotation 52
- Transporting the Windrower 53
- Storage Procedure 58
- Service Procedures 59
- Fuels, Fluids and Lubricants 61
- 50 Hours (continued) 64
- 200 Hours or Annually 65
- Diesel Engine 67
- Diesel Engine (continued) 69
- Diesel Engine: Fuel System 73
- Engine Exhaust System 78
- Engine Cooling System 79
- Electrical System 82
- Hydraulic System 91
- Header Drive: Hydraulics 94
- Traction Drive: Hydraulics 99
- MAINTENANCE/SERVICE 100
- Steering Checks 100
- MAINTENANCE/SERVICE 101
- Steering Checks (continued) 101
- Troubleshooting 103
- Procedure (continued) 105
- Friction Device Adjustment 106
- AT HALF-WEAR STAGE 110
- MAINTENANCE/SERVICE 111
- Traction Drive: Park Brake 111
- Cab Air System 112
- Maintenance Schedule 115
- MAINTENANCE RECORD 117
- (continued) 118
- TROUBLE SHOOTING 119
- Electrical 127
- Traction Drive System 128
- Header Hydraulics 131
- Header Drive 131
- TROUBLE SHOOTING 132
- Header Drive (continued) 133
- Park Brake 133
- Operator's Seat 133
- OPTIONS AND ATTACHMENTS 134
- UNLOADING 135
- Prepare to Unload 135
- Two Forklift Method 135
- UNLOADING 136
- One Forklift Method 136
- ASSEMBLY 137
- Install Tires 137
- ASSEMBLY 140
- Battery 140
- ASSEMBLY 141
- Adjustments and Checks 141
- Cab Heater 141
- Preparing the Tractor for 142
- Preparing 972 Harvest Header 145
- Radio Installation 146
- Two-Way Radio Installation 147
- Tool Box 147
- Swath Roller 148
- INDEX 150
- Self-Propelled Windrower 153
- Pre-Delivery Checklist 153
- Roof Wiring Schematic 155
- Cab Wiring Schematic 156
- Tractor Wiring Schematic 157
© 2020, manymanuals.com. All rights reserved. | 1.545 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals